The highly popular eGo-T is probably the easiest to use electronic cigarette in the world. Follow these simple steps to get started with yours.
Step cheap ray bans 1 – Unboxing
Take out all the components from your Genecigs eGo-T Starter Kit box. You will have:
Two batteries. A battery is the largest component and it looks like this:
Two Wholesale Jerseys atomisers. Here’s what an atomiser looks like:
Five cartridges. A cartridge is clear and plastic and looks like this:
You will also have an instruction manual, a USB cable charger and aÂ wall plug.
Step 2 â€“ Charging your battery
Take one battery, screw it into the cable charger, and connect the charger to either a USB port or to the wall plug provided. The indicator light on the cable charger will glow red while the battery is charging. When your battery is fully charged, the indicator light will turn green.
NOTE: The initial battery charging process can last several hours. Subsequent charges take approximately 90 minutes.
Step 3 – Filling your cartridge with e-liquid
Take one cartridge and remove the rubber cap at the wide end. Fill the empty cartridge with e-liquid in your desired flavour and nicotine concentration.
If you have imported flavourless nicotine fluid from overseas, you fake ray bans can now mix it with some of the zero nicotine e-liquid that can be legally sold in Australia to create your own flavoured nicotine solution.
Replace the rubber cap, making sure it is pressed in all the way.
<img class="aligncenter size-medium wp-image-757" title="Replacing the eGo-T cartridge cap" src="http://genecigs.com.au/wp-content/uploads/2012/01/egopress3-300×1851.png" alt="Replacing the eGo-T cartridge fake oakleys cap” width=”300″ height=”180″ />
TIP: Donâ€™t fill the cartridge up to the brim. Leave about a millimetre of space, as this will let you replace the rubber cap easily and securely.
Step 4 – Connecting your battery and atomiser
Take fahndet one battery and one atomiser and screw them together like so:
Step 5 – Connecting your atomiser and cartridge
Press the cartridge, rubber cap-side first, into the atomiser. It is important that you break the throwback nba jerseys soft seal point in the centre of the cap, or the e-liquid will not be able to flow into the atomiser to be vapourised.
Give the cartridge a few twists to make sure it is fully seated in the atomiser, with no space between them. You should hear/feel a soft â€˜popâ€™ when the seal breaks.
Step 6 – Turning on your battery
Press the battery button 5 times rapidly to turn it on. It will flash blue as it switches on, and remain in stand-by mode until you turn if off by pressing the button 5 times rapidly again.
Congratulations, you are ready to vape!
Let’s move on to the next guide, How to Vape with Your eGo-T.